• WHEN THE USER IS NOT AT THE CALL BACK NUMBER
• WHEN THE USER IS AT THE CALL BACK NUMBER

STEPS	USER	DIALMATE
Ä call DialMate (dial the number on which it is installed, e.g., "851-9566")	8519566
Ä wait for 3 rings then hang up
Ä after 7 seconds but less than 2 minutes, call DialMate again	8519566
Ä wait for DialMate to answer		answers on 3rd ring
Ä wait for one beep
Ä enter the PIN (e.g., "1234") within 3 seconds, otherwise DialMate will hang up	1234
Ä wait for two beeps
Ä DialMate is now in programming mode. Select from Programs A through I, as applicable

WHEN THE USER IS AT THE CALL BACK NUMBER

STEPS	USER	DIALMATE
Ä call DialMate and immediately hang up after one ring	8519566
Ä wait for call back		dials the call back number
Ä answer DialMate's call
Ä at the end of the message (if any), enter the PIN (e.g., "1234")	1234
Ä wait for two beeps
Ä to go to programming mode, enter "#9"	#9
Ä wait for one beep
Ä enter the PIN again	1234
Ä wait for two beeps
Ä DialMate is now in programming mode. Select from Programs A through I, as applicable, from "Programming Instructions".

Notes:

         - Make sure program instructions are entered within three seconds after the two-beep prompt.  Otherwise DialMate will time out and hang up.
         - Should you want DialMate to do an immediate call back after re-programming it to where you are, press the “9” key, hear three beeps to confirm and then hang up immediately.  DialMate will disconnect and immediately call back to your location.
         - After completing all desired programming, hang up the phone to exit.  There is no need to enter “#0” to terminate the call during remote programming.